Spacer / adapter for C-Line 1 Way Face Plate - Round Edge on C-Line modular socket system.
A 3 pack of W4 branded ring terminals with insulation sleeve. Blue type crimp fitting for use with 1.5mm2 to 2.5mm2 cable and 6mm ring to fit to M6 terminal studs.
Tri-rated HO7Z-R mains earth cable with 6mm2 conductor.
W4 inline fuse holder for use with 32mm cartridge fuses upto maximum capacity 10 Amps and fitted with 25cm of cable.
Pack of 3 x 20mm cylindrical glass cartridge fuses with 10 Amp rating for circuit protection on Caravan and Motorhome electrical system.
Pack of 3 x 20mm cylindrical glass cartridge fuses with 3 Amp rating for circuit protection on Caravan and Motorhome electrical system.
Pack of 3 x 20mm cylindrical glass cartridge fuses with 5 Amp rating for circuit protection on Caravan and Motorhome electrical system.
Pack of 4 x W4 push on female spade terminals suitable for connecting cable with conductor diameter 0.5mm2 to 1.5mm2.
Deeper 1 way faceplate with rounded edges for C-Line modular socket system. Can ONLY be used with recessed installation with C-Line Circular Back Box.
Single strand wiring harness connector for 12 volt power systems in caravan and motorhome. Connector includes both plug and socket and is usually used for a signal wire.
Circular Back Box for C-Line modular socket system. For recessed fitting in the caravan wall or bulkhead of the range of C-Line sockets, switches and outlets.
Pack of 4 x self-stripping cable connectors to splice or branch from an existing feed to a new accessory or relay. Blue colour connector for cable with conductor size from 0.65mm2 top 2mm2.
Spacer / adapter for C-Line 2 Way Face Plate - Round Edge on C-Line modular socket system.
Spacer / adapter for C-Line 3 Way Face Plate - Round Edge on C-Line modular socket system.
Small rectangular recess fitting On / Off position rocker switch. Suitable for mains 230V and 12V systems in caravans and motorhomes.
Terminal trip cable connector for electrical circuits up to 15 amps. 12 connectors in the strip can be cut down into smaller sections as required to match the number of cores in your circuit.